S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Press the cables for the passenger compartment connector socket/Accessory Electronic Module (AEM) into the installed clip. Make sure that the
cable with the radiation shield is firmly pressed into the clip and does not slide out.
Caution! Check that the cables are routed so that they do not come into contact with the alternator belt, or chafe against sharp edges in the
engine compartment.
-
Clamp the cable for the Accessory Electronic Module (AEM) with the thick cable using tie straps from the kit.
-
Reinstall the small protective panel in the wheel housing.
-
Reinstall the engine splash guard and torque tighten the screws to 25 Nm (18.5 lbf.ft.).
-
Remount the wheel and tighten the bolts to 140 Nm (103 lbf.ft.).
-
Connect and reinstall the left-hand headlamp.
Steps 35 - 38 apply to the XC90 with 6-cylinders
-
Remove the screws (2) and the engine splash guard (1).
-
Route the electrical cables down from the relay.
-
Take four tie straps from the kit and clamp the thin electrical cable (not the ground cable) to the cable for the passenger compartment connector
socket.