S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Cut away the very top of the rubber grommet.
-
Grease in the rubber grommet using low temperature grease part no. 1161417-9 in order to make it easier to install the rubber grommet in the hole
in the cowl.
-
Guide the cable into the rubber grommet.
-
Guide both cables into the hole in the cowl and press the rubber grommet into place in the hole, either by pulling it into place from inside the
passenger compartment, or carefully pressing it into place with a long large screw driver/wide end of a short pry bar.
Note! These must not be sharp or they can damage the cables/rubber grommet
-
Adapt the length of the cable from the rubber grommet, at the installed clip and out in the engine compartment.
