S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
the engine stabilizer brace. Tighten the screws
-
the screw holding the engine stabilizer brace to the bracket on the engine. Tighten
-
the battery negative lead. Also read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Final check
Check and top up if required:
-
coolant level
-
the servo fluid level. Test drive the engine.
Removing/Installing the rear camshaft seal
Preparation
Remove:
-
the screw holding the engine stabilizer brace to the bracket on the engine
-
the screws holding the engine stabilizer brace to the suspension turrets
-
the engine stabilizer brace
-
the air cleaner (ACL) cover. Place it to one side
-
the camshaft position (CMP) sensor housing and the trigger wheel.
Removing the rear camshaft seal