S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Only for cars without pre-routed Melbus cable
-
Move the gear selector lever to its rearmost position.
-
Pull the panel (1) with boot rearward and turn as illustrated.
-
Remove the screws (2) from the dashboard environment panel.
Only for cars without pre-routed Melbus cable
-
Angle the dashboard environment panel outwards so that it is possible to insert a couple of fingers between the tunnel console and the reverse of
the panel.
-
Detach the dashboard environment panel by pulling it downwards while maintaining the same angle. Some force is required because the panel is
tightly installed.
-
Disconnect the connectors on the reverse of the dashboard environment panel. Place the dashboard environment panel to one side.
Note! If any of the outer hooks break off, these must be repaired. The method for this can be found in the Workshop Manual in the section
about the dashboard.
Only for cars without pre-routed Melbus cable
-
Remove the screws from the radio bracket.
-
Pull out the bracket with the radio. Pull the lower corner while pressing downwards.
-
Detach the connectors from the radio and from the keypad to the telephone if fitted. Place the console with the radio to one side.
