V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
D4192T: If necessary, transfer the bushing for the exhaust pipe mounting.
Clean the mating surfaces thoroughly.
Install the cross member. Install the two front (long) screws. Tighten these two screws by hand.
Position the steering gear housing. Install the control arms loosely on the cross member.
Also replace the locknut for the front pin bolt on the control arm. Do not tighten the locknut yet.
Position the cross member.
-
the long screws at the front edge. Tighten to 90 Nm
-
the short screws at the rear edge. Tighten to 90 Nm.
Secure the steering gear housing on the cross member
