V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Clean the screws (A).
-
Apply locking fluid (P/N 1161053) to the screws (A).
Install:
-
the frame on the seat
-
the screws (A). Tighten to 25 Nm.
Connect and route the wiring. Secure using tie straps.
Reinstall the front seat.
Backrest Motor For the Power Seat, Replacing
Backrest Motor For The Power Seat, Replacing
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Removal
Removing The Backrest Motor
