V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Automatic Transmission Fluid: Testing and Inspection
Checking and adjusting the oil
Note: Oil grade: Only ATF oil, Volvo P/N 1161540-8 (1 liter containers) may be used.
Warning: Avoid skin contact with the transmission fluid.
Checking the oil level
Conditions
The difference between the MAX and MIN volumes is 0.2 liters. Check the oil temperature in the transmission.
At room temperature (+20°C) the oil level is close to the MIN mark on the "cold area".
At room temperature (+20°C) and low oil level the oil barely reaches the dipstick.
The "cold range" (+40°C) is reached after approximately 15 minutes idling in the workshop, while the "hot range" (+80°C) is reached after
approximately 30 minutes highway driving at an air temperature above +15°C.
Note: The check must be carried out at an oil temperature of +80°C. Go to vehicle communication function group 4. Select the digital display
parameter. Select the parameter for the transmission oil temperature.
Preparing to check the oil level
Park the car on a level surface.
Apply the parking brake.
Let the engine idle.
Move the gear selector lever to position P.
Move the gear selector through all positions.
Wait in each position for approximately 3 seconds
Move gear selector to position P and wait approximately 2 minutes before checking the oil level.
The dipstick must be pushed down as far as possible into the dipstick tube.
Caution: Wipe the dipstick with a nylon cloth or similar. Do not use a cloth which may leave fluff or threads.
Low level (topping up)
Top up with oil through the dipstick pipe
Take account of the temperature when topping up with oil.
High level (overfilling)
Warning: The oil may be very hot if the car has just been driven. Avoid skin contact with the transmission fluid.
Warning: The transmission must not be operated if the oil level is too high. This can cause increased operating temperatures and oil leakage.
Drain off oil
