V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Adjusting the contact reel
Before installing the steering wheel, the contact reel must be placed in its center position.
When checking the center position, the black dot on the yellow indicator must be directly opposite the center arrow.
If the center position is indicated, it must be possible to turn the inner part of the contact reel approximately 2 turns both clockwise and
counter-clockwise from the indicated middle position.
If the center position is incorrectly indicated, it can be adjusted.
To adjust the center position, first turn the inner part of the contact reel counter-clockwise to its limit position, where resistance will be felt.
From this position, turn the inner part of the contact reel clockwise slightly more than two turns.
Adjust the yellow indicator by turning until the black dot is directly opposite the center arrow.
Install:
-
the steering wheel according to Steering wheel module and steering wheel See: Air Bag/Service and Repair/Removal and Replacement/Airbag
Driver's Side (SRS), Replacing
-
the steering wheel module according to Steering wheel module and steering wheel See: Air Bag/Service and Repair/Removal and
Replacement/Airbag Driver's Side (SRS), Replacing
-
the date decal for the SRS Airbag according to Steering wheel module and steering wheel See: Air Bag/Service and Repair/Removal and
Replacement/Airbag Driver's Side (SRS), Replacing.
Finish according to Note when disconnecting and connecting the battery lead See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
SRS Ignition Cable Igniter Connector
SRS ignition cable igniter connector
SRS ignition cable igniter connector
