V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Air Bag Control Module: Procedures
Preparations
Prepare the car.
Removing The Control Module
Remove:
-
the rear center console
-
the three screws.
Press in the lock (1) on the connector.
Move the mounting bracket (2) from the lug.
Disconnect the connector (3).
Remove the control module.
CAUTION: Do not touch the pin on the connectors. Static discharge may damage the control module.
Installing The Control Module
CAUTION: Ensure that there is no dirt between the control module and the body bracket.
Connect the connector.
Lock the connector with the mounting bracket (2).
Install the sensor module using new screws. Tighten the screws. Tighten to 10 Nm.
