V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
insert the right tie rod through the hole in the fender liner and steering gear to the right Then raise the steering gear housing and slide the left tie rod
out through the fender liner (only applies to left-hand drive cars).
insert the left tie rod through the hole in the fender liner and steering gear to the left Then raise the steering gear housing and slide the right tie rod out
through the fender liner.
Check that the boots are the same length (only applies to right-hand drive cars).
Install:
-
the steering shaft on the pinion shaft
-
the right mounting bracket. Tighten to 69 Nm (only applies to left-hand drive cars)
-
the left mounting bracket. Tighten to 69 Nm (only applies to right-hand drive cars)
-
new O-rings on the pipes
-
the pipes on the steering gear housing. Tighten to 15 Nm
-
the left mounting bracket. Tighten to 69 Nm (only applies to left-hand drive cars)
the right mounting bracket. Tighten to 69 Nm (only applies to right-hand drive cars)
-
the pipe bracket. Tighten to 25 Nm. Wipe off any fluid spillage.
Installing surrounding components
Install:
-
the heat deflector plate. Tighten to 10 Nm
-
the tie rods on the wheel spindles.
-
the rear engine mounting on the transmission.
Tighten to 60 Nm.
Installing the front exhaust pipe
Install the front exhaust pipe.
Installing the steering gear housing on the steering column
Install:
-
the front wheel. Lower the car
-
the pinion shaft by pressing down as far as possible. Tighten the screw. Tighten to 17 Nm
-
a new tie strap on the intermediate plate
-
the floor carpet on the driver's side.
