volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Clutch, M/T > < Wiring Harness, A/T|Service and Repair|Page 5545
Page 10
background image

Tighten the oil pipe cap nut on the control system cover.

Install:

-

the air cleaner (ACL) housing assembly, see  Replacing the air cleaner (ACL) See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine
Performance Checks/Air Cleaner Housing/Service and Repair/Removal and Replacement 

-

the battery shelf

-

the battery.

Note! When installing the battery lead, see  Note when disconnecting and connecting the battery lead See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.

Filling and checking oil

Fill with oil, P/N 1161540-8 to the volume previously noted when the transmission was drained.
Top up and check the oil level. See  Checking and adjusting the oil, AW55-50/51SN See: Service and Repair/Procedures/Checking Oil Level.

Note! After replacing the transmission oil, the "Transmission oil change" counter must be reset. Use VIDA vehicle communication to reset the
counter.

Checking diagnostic trouble codes (DTCs)

Check and erase any diagnostic trouble codes (DTCs).

Clutch, M/T > < Wiring Harness, A/T|Service and Repair|Page 5545