V50 L5-2.4L VIN 38 B5244S4 (2006)
Note! Do not damage the painted roof trims. They scratch easily.
-
Measure the front edge of the right-hand roof trim for cutting as illustrated. Measure from the ends (1) of the two profiles on the inside of the roof
trim
-
Mark the same dimensions on top of the two profiles and at the sides so that the cut on the top of the roof trim can be marked.
-
Carefully mark the top of the roof trim where it will be cut
-
Pull off the rubber strip between the markings on both sides of the roof trim strip so that the rubber strips can be cut off
-
Cut the rubber strips so that they protrude approximately 5mm (3/16 ") from the edge of the sections of the roof trim strip which are to remain in
place.
-
Wrap the section of the roof trim to be secured in the vice. Use plenty of paper or cloth to protect the paintwork on the roof trim
Note! Use jaw protectors with a recess in the centre on the vice.
Position the roof trim in the recesses in the vice.
Note! Do not over-tighten the vice or the roof trim may deform.
-
Carefully cut at the marking furthest in on the roof trim, gently pressing the roof trim. Hold the other end of the roof trim with your free hand to
