V50 L5-2.4L VIN 38 B5244S4 (2006)
keep the trim stable whilst cutting.
-
Remove the long section of the roof trim from the vice
-
Secure the cut off section with the section (1) to be cut off in the vice
-
Cut the roof trim in the same way as in the previous point.
Cutting the rear edge, right-hand roof trim
-
Measure the rear edge of the right-hand roof trim for cutting as illustrated. Measure from the ends (1) of the two profiles on the inside of the roof
trim
-
Then mark the same dimensions on top of the two profiles and at the sides so that the cut on the top of the roof trim can be marked.
-
Carefully mark the top of the roof trim where it will be cut
-
Pull off the rubber strip between the markings on both sides of the roof trim strip so that the rubber strips can be cut off
-
Cut the rubber strips so that they protrude approximately 5mm (3/16 ") from the edge of the sections of the roof trim strip which are to remain in
place.
