V50 L5-2.4L VIN 39 B5244S7 (2005)
Remove the 1 screw for the holder.
Remove the sensors from the recesses.
Disconnect all the remaining cable terminals and cables apart from:
- those for the overheat protection thermostat at positions 5 and 6 (red cables)
- those for the engine coolant temperature sensor at positions 3 and 4 (blue cables)
The connector is supplied with the replacement part.
Installation
Installing the overheat protection thermostat / engine coolant temperature sensor
Install the sensors and position the cable harness along the recesses for the heat exchanger. Ensure that the cable grommet is correctly located in relation
to the fan motor cover.
Install the holders for the sensors using 1 screw. Tighten.
