V50 L5-2.4L VIN 39 B5244S7 (2005)
Lower the vehicle.
Disconnect the pipe/hose connector to the receiver adjacent to the power steering fluid reservoir. See the illustration.
Route the pipe / hose down to the compressor under the vehicle.
Installing the pipe/hose between the compressor and the receiver
Note! For tightening torques, see Specifications. See: Body and Frame/Specifications
Place the pipe/hose for the compressor in position by the upper connector to the receiver.
Install:
-
the pipe coupling, 1 M8. Ensure that the O-rings are securely located between the receiver and the pipe/hose. Tighten the screw
-
the pipe coupling by the compressor, 1 M8. Make sure the O-rings are securely located. Tighten the screw.
Carry out finishing work. See: Finishing.
Finishing
Checking the function and leak tracing
Vacuum pump the air conditioning (A/C) system. See: Vacuum pumping See: Heating and Air Conditioning/Service and Repair/Vacuum Pumping.
Fill the AC-system with refrigerant acc. to: Refrigerant, filling See: Heating and Air Conditioning/Service and Repair/Refrigerant, Filling.
Leak trace the air conditioning (A/C) system. See: Leak detection, tracer agent See: Heating and Air Conditioning/Testing and Inspection/Component
Tests and General Diagnostics/Leak Detection, Tracer Agent or: Leak tracing, electronic leak tracer See: Heating and Air Conditioning/Testing and
Inspection/Component Tests and General Diagnostics/Leak Tracing, Electronic Leak Tracer.
Installing shield and bumper cover
