V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the screws.
Use a 6 mm torx external socket
-
Carefully pull the control module down so that the terminal pin on the control module comes loose inside the ABS modulator
-
Continue pulling the control module down towards the brake lines and lift it out.
Checking the new control module
Check:
-
the control module is correct (compare to the old one)
-
that none of the pins on the connector are damaged
-
that there are no contaminants on the mating surfaces between the control module and the ABS hydraulic modulator
-
that no parts of the old control module seals remain on the old ABS hydraulic modulator valves.
Installation
Installing the control module
Position the control module on the brake lines.
Center the control module with the ABS modulator valves so that the terminal pins are correctly positioned in the modulator.