V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Press the control module up so that the terminal pins connect.
Install:
-
the screws.
Tighten to 1.8 Nm
-
the connector on the control module. Lock the connector
-
the integrated relay/fusebox and the connector for the ABS unit. See Brake pipe master cylinder / ABS unit, replacing See: Brakes and Traction
Control/Hydraulic System/Brake Hose/Line/Service and Repair/Brake Pipe Master Cylinder / ABS Unit, Replacing
-
the integrated relay / fusebox.
Tighten the screw. Tighten to 10 Nm
-
the air cleaner (ACL) housing. See Brake pipe master cylinder / ABS unit, replacing See: Brakes and Traction Control/Hydraulic System/Brake
Hose/Line/Service and Repair/Brake Pipe Master Cylinder / ABS Unit, Replacing.
Installing the battery lead
Install the battery cable. See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Loading software
Note! Switch on the ignition.
Order applicable software.
Visual check
Turn on the ignition.
Wait five seconds and until the symbol for the brakes on the dashboard has gone out.
In the event of a fault (the symbol is lit).
Check that the connector is connected.