V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
tape (2). Secure the wiring to prevent catching or rubbing
-
Connect the wiring (3, 4) to the relevant aerial amplifier.
-
Route the left-hand side cable harness from the front edge of the wheel arch to the aerial amplifier at the top edge of the rear side window, and to
the DVD reader
-
Route the cable harness with the two single cables along the front edge of the wheel arch. Continue along the C-post and along the upper edge of
the rear side window. Continue along to the relevant aerial amplifier
-
Secure the cable harness at the existing wiring and the plastic hose. Use tie straps (1) from the kit. Also secure at the cantrail. Use pieces of butyl
tape (2). Secure the wiring to prevent catching or rubbing
-
Connect the wiring (3, 4) to the relevant aerial amplifier.
-
Remove the four screws holding the DVD reader at the bracket
-
Pull out the DVD reader
-
Route the remaining section of the cable harness on the left-hand side: the seven pin cable with the green connector and the DIN-cable to the DVD
reader.
Route the cable harness on top of the wheel arch under the insulation panel, through the hole in the bodywork and out through the bracket for the DVD
reader to the DVD reader
-
Connect the green connector (1) to the DVD reader
-
Connect the DIN cable (2) to the DVD reader
-
Reinstall the DVD reader in the bracket. Tighten.
