V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
-
Carefully remove the rear screw for the gas generator for the right-hand side inflatable curtain
-
Install the TV aerial amplifier (1) (from the kit) so that the mounting for the gas generator rests above the aerial amplifier mounting
-
Tighten the aerial amplifier
-
Connect the switches (2)
-
Install the small TV aerial amplifier (3) from the kit. Insert the locating pin (4) in the hole. Tighten using the screw
-
Connect the switch (5).
-
Bend up the insulation panels (1) towards the reverse of the rear backrest
-
Position the cable harness (from the kit) as illustrated. The junctions are situated on the section of cable harness which is routed on the left-hand
side of the car. Ensure that the junction with the green 7-pin connector, the two grey connectors and the DIN connector are positioned as illustrated
-
Route the left-hand cable harness under the strut (2) for the wheel arch in front of the left-hand shock absorber mounting
-
Route the cable harness under the insulation panel under the left-hand rear backrest. Continue to the front edge of the left-hand rear wheel arch
-
Route the right-hand cable harness in front of the strut (3) for the right-hand wheel arch. Continue in the same way as for the left hand cable
harness to the front edge of the wheel arch
-
Secure the cable harness to the cargo compartment floor and at the cable duct. Use two pieces of butyl tape (4) and a tie strap (5) from the kit.
-
Route the right-hand cable harness from the front edge of the wheel arch along the C-post and the upper edge of the rear side window. Continue
along to the relevant aerial amplifier
-
Secure the cable harness to the existing wiring and the plastic hose. Use tie straps (1) from the kit. Also secure at the cantrail using pieces of butyl
