V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Unscrew the screw holding the connector so that it is free of its threads. Check that the screw is free with your fingers.
Disconnect the connector. Use an open wrench and a support. See the illustration.
NOTE: Do not damage the terminal pins. Always check that the control module and control module box connectors do not have bent or damaged
terminals or socket / sleeves. This may have been the cause of the fault.
Remove all relays and shunts bridged to the control module. Note the locations.
Release the catch on the rear. Use a screwdriver.
Lift and pull out the control module.
Check
Check that the control module connectors are intact.
Installing the control module
-
Press the control module into place so that the catch on the rear engages
-
Position the connector. Carefully press the connector down.
