V70 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Turn the ignition key to position 0.
Move the gear shift lever to position P.
Position a 5 mm drill bit in the housing above the yellow locking sleeve. This is to get the lever into the secured position.
Install the cable on the housing and on the threaded end in the groove on the yellow locking sleeve.
Press the locking sleeve so that it locks the cable.
Check
Check that the key cannot be removed when the gear selector is in any other position than P.
Installing the center console
Install the center console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console, Replacing
Gear Selector Lever Knob, Spaceball
Gear selector lever knob, Spaceball
Gear selector lever knob, Spaceball
