V70 GL L5-2.4L VIN 55 B5254S (1998)
Remove the five nuts securing the steering gear to the subframe.
Remove the plastic nut holding the tab in the right fender liner and bend the tab to one side.
Remove the screws for the right engine mounting.
Position a mobile jack at the rear edge of the sub-frame.
Remove
-
the four screws holding the sub-frame brackets to the bodywork on both sides.
-
the two screws together with the brackets and washers.
Slacken off the front sub-frame screws 10 - 15 mm (0.39" - 0.5979).
Lower the rear edge of the sub-frame. Ensure that the steering gear screws release from the frame.
Remove the mobile jack.
Position a container to catch oil under the steering gear and remove the oil pipes from the steering gear. (Applies only to left-hand drive cars.)
Remove
-
the screw in the steering shaft joint. Push the joint clear of the steering gear.
-
the screw securing the steering gear to the rear engine pad.
Allow the steering gear to rest on the sub-frame and remove the heat deflector plate (TX25). (Applies only to right-hand drive cars).
Lift out the steering gear to the right.
Installing steering gear
Note! When replacing the steering gear and the mounting for the center mounting: Do not tighten the bracket screws yet.
Left-hand drive cars
Transfer the heat shield.
Right and left hand drive cars
