V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
-
Peel backing paper from tapes on support.
-
Attach support to body flange and to edge between flange and roof (1).
-
Apply PUR bead to body flange below support. Bead should be 6-7 mm high and should extend from A- post to A-post (2).
INSTALL LOWER SPACERS:
Measure off 260 mm from inner edge of each front fender along bottom of windshield frame.
-
Use cleaning agent H to clean area starting 260 mm from edge of each front fender (equal to length of spacers).
-
Apply double-sided adhesive tape to rear of spacers.
-
Attach spacers to windshield frame.
-
Remove backing tape from front of spacers.
INSTALLATION OF WINDSHIELD
-
Place windshield on stand.
-
Measure off 740 mm from top of windshield (where PUR bead is to be applied to glass).
-
Mark with masking tape.
-
Install guide moulding for wiper well cover panel.
-
Attach suction cups to windshield.
WARNING: USE OF PROTECTIVE GLOVES IS RECOMMENDED. ENSURE THAT VENTILATION IS SATISFACTORY.