V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
-
the blind cover plug.
Turn the crankshaft slightly clockwise.
Install crankshaft stop 999 5451 ADJUSTMENT TOOL See: Tools and Equipment/999 5451 Adjustment Tool. Ensure that it bottoms out against the
cylinder block.
Turn the crankshaft counter-clockwise until it stops against the crankshaft stop.
Check that the marking on the crankshaft timing gear pulley corresponds to the marking on the oil pump.
Installing the cylinder head
Ensure that all studs at the exhaust ports are tightened
Lubricate the studs with paste 116 1408.
Install a new cylinder head gasket.
Get help and install the cylinder head.
Lubricate and install all the screws (use new screws).
Tighten the screws as illustrated. Tighten. See Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque. Use protractor 951
2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Installing valve lifters and camshafts
Lubricate the valve lifter wells.
Note! If the cylinder head has been replaced, the valve clearance must be adjusted. See Valve clearance See: Cylinder Head Assembly/Valve
Clearance/Adjustments.
Install all valve lifters
Lubricate the camshaft bearing positions
Install the intake camshaft. Ensure that the groove at the back of the camshaft is above an imaginary center line
Position the exhaust camshaft. Ensure that the groove at the back of the camshaft is below an imaginary center line.
Applying liquid gasket
