V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Cylinder Head Gasket: Specifications
Cylinder head
Tighten the screws in sequence from the center and outwards.
Use new screws.
Stage 1 ..................................................................................................................................................................................................................... 20 Nm
Stage 2 ..................................................................................................................................................................................................................... 60 Nm
Stage 3 ....................................................................................................................................................................................... angle-tighten 130 degrees
Manifold (cylinder head side) ..................................................................................................................................................................................... 25 Nm
Intake manifold ........................................................................................................................................................................................................... 19 Nm
Maximum Out-of-true
Front-rear....................................................................................................................................................................................................................0.50 mm
Lateral.........................................................................................................................................................................................................................0.20 mm
Cylinder head height....................................................................................................................................................................................129.00 ± 0.05 mm
Maximum machining...................................................................................................................................................................................................0.30 mm
CAUTION: Scratches and corrosion to the cylinder head gasket face should only be machined on a flat cylinder head.