V90 L6-2.9L VIN 96 B6304S (1998)
NOTE: Do not grease pack hub.
-
It is packed with the correct amount of special grease.
-
The sleeve used in disassembly is now pushed out by the king pin.
4. Check that the outer bearing inner ring is in position.
-
Adjust bearing position if necessary.
5. Tighten nut (use a new nut).
-
Tighten so that the axial play just disappears.
-
Then tighten nut to 100 Nm (73.8 ft. lbs.).
-
Finally angle tighten the nut to 45°.
6. Install cap (use a new one).
-
Use tool with a rubber mallet.
