XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Take the receptacle housing section of the connector with the two metal strips from the kit.
-
Carefully place the connector in the receptacle housing section with the round section (1) of the connector aligned in the corresponding cut-out (1)
in the receptacle housing section. The upturned section (2) of the connector must also be aligned in the corresponding cut-out in the receptacle
housing section.
Illustration B
-
Carefully place the other receptacle housing section on the connector. The upturned section (2) of the connector must be aligned in the
corresponding cut-out in the receptacle housing section.
-
Press the receptacle housings and connector together until the four catches engage.
Note! The components are small and fragile, so take care when aligning the connector and receptacle housings in each other to avoid damage
and resulting poor contact.
-
Reinstall the rubber grommet in the body and boot lid.
Illustrations A and B