XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Route the cable harness to the left towards the D pillar.
-
Route at the D pillar along the existing cable harness to the rear edge of the fuse holder.
-
Secure it using seven cable ties along the existing cable harness.
Note! Ensure that the cable does not chafe against the panel edge in the body where it exits the rubber grommet in its right-hand mounting.
-
Insert a piece of wire under the rear edge on the load floor support along the thick cable harness and forward.
-
Tape the connector and a piece of the cable on the routed cable harness (Image B) on the wire.
-
Carefully pull the cable harness forward.
-
Clamp the cable at the cradle on the bracket for the washer hose and under the fuse holder.