XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Measure the dimensions from the lugs in the floor and from the edge at the floor's embossing, and apply pieces of tape for marking the location of
the ECU.
-
Position the ECU along the markings and mark out the last short end.
-
Clean the surfaces on both sides of the embossing in the floor using isopropanol and wipe dry.
-
Clean the two surfaces on the short sides of the ECU. There are faint marks where the Velcro strips are to be applied.
Note! Ensure to turn the ECU correctly.