XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Install the front engine block heater socket with the guide pin in the large hole.
-
Route the cable in so that it runs down on the inside of the left-hand bracket for the skid plate.
-
Align the front engine block heater socket so that the long sides of the mounting plate are parallel with the edges of the surface into which the
mounting plate shall be screwed.
-
Mark out for drilling the hole for the screw for the mounting plate.
-
Drill a hole with a - 5 mm (3/16 ") diameter drill bit for the screw for securing the front engine block heater socket's mounting plate.
-
Secure the front engine block heater socket with a screw and nut in the drilled hole and tighten.
