XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Connect the pre routed cable to the accessory electronic module (AEM) connector in terminal 5.
Note! Number markings can be found on the top and bottom of the switch. The markings are very small. Ensure accuracy when installing the
cable.
-
Reinstall the switch in the connector. Lock into place using the catch
-
Press the connector into the control module and lock using the handle
-
Press the control module into the bracket.
-
Reinstall the panels in the cargo compartment
-
Reinstall the cargo compartment carpet
-
Reinstall the sill trim panel in the rear door
-
Reinstall the side cushion
-
Reinstall the seat cushion
-
Fold the backrest back into place
-
Fold the front seat carpet back into place
-
Connect the cable for the passenger compartment connector socket. Tighten the cable
-
Reinstall the sill trim panel in the front door
-
Reinstall the soundproofing panel and side panel for the centre console
-
Reinstall the centre air baffle
-
Reinstall the engine cover. Tighten the screws. Tighten to 24 Nm (18 lbf.ft)
-
Reinstall the air baffles at the sides (if applicable)
-
Program the software according to the service information in VIDA.
Point - applies to the XC90
