XC90 AWD V8-4.4L VIN 85 B8444S (2005)
-
Cut a 2 mm (5/64") wide groove through the plate leading in to the hole.
-
Measure up to drill the lead-in in the upper plate in the rear section on the left and right-hand sides of the cut-out as illustrated
-
Pre-drill using a 3 mm (1/8") diameter drill bit. Then drill out the hole to a diameter of 8 mm (5/16").
-
Cut a 2 mm (5/64") wide groove through the plate leading in to the hole
-
Repeat the operation on the other side of the cut-out.