XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Clean the surface where the inner base module is to be positioned using the cleaning cloth from the kit
-
Wipe dry
-
Remove the backing from the inner base module
-
Position the inner base module horizontally on the side window, in line with the rear end of the headlining. The upper rear corner of the inner base
module must be positioned edge to edge with the tinted area of the side widow as illustrated.
-
Install the aerial on the external base module.
-
Clean the surface where the external base module is to be positioned using the cleaning cloth from the kit
-
Wipe dry
-
Remove the backing from the external base module. Press the external base module into place on the side window opposite the inner base module
-
Press hard on points 1, 2, 3, 4 and 5, in order, for 3-4 seconds
-
Ensure that the tape is sealed around the external base module. For optimum adhesion, heat the glass. Use a hair dryer or similar.
Cable routing and connecting the combined aerial