GVS L4-1116cc 1.1L SOHC VIN 2 2-bbl (1988)
Pick-Up Coil: Testing and Inspection
Fig. 4 Pickup assembly test
1987-88
1.
Disconnect harness from control module.
2.
Connect a suitable ohmmeter to pickup assembly connector, Fig. 4.
3.
Ohmmeter should indicate 990-1210 ohms.
4.
Connect one ohmmeter lead to distributor body. Ohmmeter should indicate infinity. If not replace pickup assembly.
5.
Using a non-magnetic feeler gauge check gap between stator pole and trigger, adjust if necessary.
6.
Gap should be .0118-.0196 inch (.3-.5 mm).
