GVS L4-1116cc 1.1L SOHC VIN 2 2-bbl (1988)
Ignition Control Module: Testing and Inspection
Fig. 5 Control module test.
Fig. 6 Control module test.
1.
Connect primary leads to coil, pickup assembly to control module and resistor lead.
2.
Disconnect high voltage wire from distributor. Do not disconnect wire from coil assembly.
3.
Using a suitable high voltage holder, hold wire approximately .196 inch (5 mm) from ground, crank engine and check for spark, Figs. 5 and 6.
4.
If no spark appears, replace control module.