3.2TL TYPE S V6-3.2L SOHC (2002)
Installation
1. Align the front wheels straight ahead.
2. If not already done, disconnect the battery negative cable, and wait at least 3 minutes.
3. Set the cancel sleeve (A) so that the projections (B) are aligned vertically.
4. Carefully install the cable reel (A) on the steering column shaft. Then connect the dashboard wire harness B 4P connector (B) to the cable reel 4P
connector (C), and connect the cable reel connector (D) to the SRS main harness 4P connector (E).
5. Install the steering column covers.
6. If necessary, center the cable reel. (New replacement cable reels come centered.) Do this by first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise (approximately 2 1/2 turns) until the arrow mark on the cable reel label points straight up.