3.2TL TYPE S V6-3.2L SOHC (2002)
2. Remove the screw from the armrest portion of the door panel. Release the clips that hold the door panel (A) with a commercially available trim
pad remover (8), then remove the door panel by pulling it upward, and disconnecting the power window switch connector (C). Remove the door
panel with as little bending as possible to avoid creasing or breaking it.
3. Install the panel in the reverse order of removal, and note these items:
-
Replace any damaged clips.
-
Make sure the connector is plugged in properly, and the rod is connected properly.
-
Check the window and power door lock operation.
