3.2TL TYPE S V6-3.2L SOHC (2002)
Harmonic Balancer - Crankshaft Pulley: Specifications
Crankshaft and Piston Installation
Special Tools Required
^
Driver 07749-0010000
^
Oil Seal Driver Attachment, 80 mm I.D. 07VAD-P8A010A
1. Measure the diameter of each connecting rod bolt at point A and point B.
2. Calculate the difference in diameter between point A and point B.
Point A-Point B = Difference in Diameter
Difference in Diameter: Specification: 0 - 0.1 mm (0 - 0.004 inch)
3. If the difference in diameter is out of tolerance, replace the connecting rod bolt.
4. Check the connecting rod bearing clearance with plastigage.
5. Check the main bearing clearance with plastigage.
6. Install the bearing halves in the cylinder block and connecting rods.
7. Apply engine oil to the main bearings and rod bearings.
8. Lower the crankshaft (A) into the block.
