3.2TL TYPE S V6-3.2L SOHC (2002)
Crankshaft Main Bearing Seal: Service and Repair
Pulley End Crankshaft Seal
Pulley End Crankshaft Seal Installation - In-car
Special Tools Required
Oil Seal Driver 07LAD-PT3010A
1. Dry the crankshaft oil seal housing.
2. Apply a light coat of grease to the crankshaft and to the lip of the seal.
3. Using the seal driver, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess
grease off the crankshaft, and check that the oil seal lip is not distorted.
