acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Variable Induction Control Actuator|Locations|Page 6727 > < Variable Induction Control Actuator|Locations|Page 6725
Page 3
background image

13. Start the engine.

14. Measure voltage between the IMRC module 14P connector terminal No.6 and body ground.

Is there 5 V with engine speed below 3,500 rpm, and is there 0 V with engine speed above 4,000 rpm?

YES - Replace the IMRC module. 

NO - Go to step 15.

15. Turn the ignition switch OFF.
16. Disconnect PCM connector A (32P).

17. Check for continuity between the IMRC module 14P connector No.6 terminal and body ground.

Is there continuity?

YES - Repair short in the wire between the IMRC module and the PCM. 

NO - Go to step 18.

18. Connect PCM connector terminal A13 to body ground with a jumper wire.

Variable Induction Control Actuator|Locations|Page 6727 > < Variable Induction Control Actuator|Locations|Page 6725