3.2TL TYPE S V6-3.2L SOHC (2002)
19. Coat the new pump cover seal (A) with power steering fluid, and install it into the groove in the pump cover (B).
20. Install the outer side plate (C) over the 2 roll pins (D).
21. Set the pump cam ring (A) over the 2 roll pins with its mark (B) facing downward.
22. Assemble pump rotor (A) pump cover (B) with its mark (C) facing downward.
23. Set the 10 vanes (D) in the grooves in the rotor. Make sure that the round ends (E) of the vanes are in contact with the sliding surface of the cam
ring.
24. Coat the new O-ring (A) with power steering fluid, and install it into the groove in the side plate (B).
25. Install the side plate on the cam ring (C) by aligning the roll pins set holes (D) in the side plate with the roll pins (E).