3.2TL TYPE S V6-3.2L SOHC (2002)
Steering Wheel: Service and Repair
Removal and Installation
Removal
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the before performing repairs or
service.
1. Align the front wheels straight ahead, then remove the driver's airbag assembly from the steering wheel.
2. Disconnect the radio remote switch connectors (A) and cruise control switch connector (B).
3. Loosen the steering wheel bolt (A), and install a steering wheel puller (B) on the steering wheel (C). Free the steering wheel from the steering
column shaft by turning the pressure bolt (D) of the puller.
Note these items when removing the steering wheel:
-
Do not tap on the steering wheel or the steering column shaft when removing the steering wheel.
-
If you thread the puller bolts (E) into the wheel hub more than 5 threads, the bolts will hit the cable reel and damage it. To prevent this, install
a pair of jam nuts 5 threads up on each puller bolt.
4. Remove the steering wheel puller, then remove the steering wheel bolt and steering wheel from the steering column.
Installation