3.2TL TYPE S V6-3.2L SOHC (2002)
1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise approximately 2 and half turns. The arrow mark (B) on the cable reel label
point should point straight up.
2. Position the 2 tabs (A) of the turn signal canceling sleeve (B) as shown, and install the steering wheel on to the steering column shaft, making sure
the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the canceling sleeve. Do not tap on the steering wheel or steering
column shaft when installing the steering wheel.
3. Install the steering wheel bolt and tighten it to 39 Nm (4.0 kgf-cm, 29 ft. lbs.).
4. Connect the radio remote switch connector and cruise control switch connector.
5. Install the driver's airbag and confirm that the system is operating properly.
6. Check the horn, radio remote switches, cruise control set/resume switches and turn signal canceling for proper operation.