3.2TL TYPE S V6-3.2L SOHC (2002)
12. Glue the clips (A) with adhesive tape (3M 4216, or equivalent) and spacers (B) with adhesive tape (3M 5357, or equivalent) to the inside face of
the rear window as shown. If necessary, apply primer (3M N2.00, or equivalent) to the areas where the window antenna terminal base (C) will be
glued, then glue the base on with adhesive tape (3M 4211, or equivalent):
-
Be sure the fasteners (and window antenna terminal base cover) line up with the alignment marks (D).
-
Be careful not to touch the rear window where adhesive will be applied.
13. Apply the adhesive tape (A) (3M 4216, or equivalent) to the edge of the rear window (B):
-
Be sure the adhesive tape lines up with the alignment marks (C).
-
Be careful not to touch the rear window where adhesive will be applied.