3.2TL TYPE S V6-3.2L SOHC (2002)
14. Glue the molding (A) around the edge of the rear window (B):
-
Be sure the joint (C) lines up with the alignment mark (D).
-
Be careful not to touch the rear window where adhesive will be applied.
15. Install the clips.
16. Set the rear window in the opening, and center it. Make alignment marks (A) across the rear window and body with a grease pencil at the four
points shown. Be careful not to touch the rear window where adhesive will be applied.
17. Remove the rear window.