3.2TL TYPE S V6-3.2L SOHC (2002)
15. Make alignment marks (A) across the windshield and body with a grease pencil at the four points shown. Be careful not to touch the windshield
where adhesive will be applied.
16. Remove the windshield.
17. With a sponge, apply a light coat of glass primer around the edge of the windshield (A) between the dam (B) and molding (C) as shown, then
lightly wipe it off with gauze or cheesecloth:
-
Apply glass primer to the molding.
-
Do not apply body primer to the windshield, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the windshield properly, causing a leak after the
windshield is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.