3.5RL V6-3474cc 3.5L (2001)
19. Turn the special tool so it will fit through the end of the gearbox housing, then position special tool on the backup ring.
NOTE: Make sure that the special tool is securely positioned on the backup ring edges.
20. Insert a 24" long 3/8" drive extension into the cylinder and the special tool from the gearbox side.
CAUTION: Be careful not to damage the inside surface of the cylinder wall with the tools.
21. Set the gearbox housing in a press, then press out the cylinder end seal, and backup ring from the gearbox housing.
CAUTION:
-
Keep the tool straight to avoid damaging the cylinder wall. Check the tool angle, and correct it if necessary, when removing the cylinder end
seal.
-
Use a press to remove the cylinder end seal. Do not try to remove the seal by striking the tool. It will break the backup ring, and the cylinder