3.5RL V6-3474cc 3.5L (2001)
Example: Measurement is 0.28 mm (0.011 inch): 0.07 - 0.28 = 0.42 mm (0.028 - 0.011 = 0.017 inch)
The selected shims should be 0.25 mm (0.010 inch) and 0.15 mm (0.006 inch) in thickness.
If the required shim thickness is 0.10 mm or less, no shims are necessary.
55. Set the selected 44 mm shims on the bearing surface of the gearbox housing.
56. Coat the new O-ring with grease, and carefully fit it on the valve housing.
57. Apply grease to the needle bearing in the gearbox housing.
58. Install the valve body unit on the gearbox housing by engaging the gears.
NOTE: Note the valve body unit installation position (direction of line connection).
59. Tighten the flange bolts to the specified torque.
60. Install cylinder lines A and B.
NOTE:
-
Clean the joints of cylinder lines A and B thoroughly. The joints must be free of foreign material.
-
Install cylinder lines A and B by fighting the flare nuts by hand first, then tighten the flare nuts to the specified torque.