acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

All Technical Service Bulletins for Glove Compartment:|96-042|Page 8459 > < Customer Interest for Glove Compartment:|96-042|Page 8456
Page 1
background image

Glove Compartment: All Technical Service Bulletins
Ticking Noise From The Glove Box

September 17, 1996

BULLETIN NO.
96-042

YEAR
1997

MODEL
2.2CL

VIN APPLICATION
ALL

Ticking Noise From the Glove Box

SYMPTOM

A ticking noise from the glove box while driving.

PROBABLE CAUSE

The right-hand corner of the glove box contacts the instrument panel.

DIAGNOSIS

Test-drive the car to reproduce the noise. When you hear the noise, open the glove box; if the noise goes away, do the CORRECTIVE ACTION. If you
still hear the noise with the glove box open, continue with normal troubleshooting until you find the cause.

CORRECTIVE ACTION

Apply slip tape to the corner where the glove box contacts the instrument panel.

1.

Cut an 80-mm-long piece of slip tape from the roll (see PARTS INFORMATION). Then trim a 3-mm-wide strip lengthwise from the piece of
tape. (This will minimize tape trimming after you install it.)

2.

Open the glove box, and apply the tape to the ridge on the instrument panel, beginning at the upper right corner.

3.

If needed, carefully trim off any tape that sticks out above or below the ridge.

All Technical Service Bulletins for Glove Compartment:|96-042|Page 8459 > < Customer Interest for Glove Compartment:|96-042|Page 8456