CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Brake Line Placement
3. Install the modulator unit in the reverse order of removal.
NOTE: Check the letters stamped on the modulator body, and connect the brake lines properly. Tighten the flare nuts.
Specs:
Flare nuts 19 Nm (14 lb.ft.)
4. Start the engine and let it idle for a minute.
Check that:
-
ABS indicator light is off.
-
Brake fluid is not leaking from the brake line joints.
5. Stop the engine.
6. Check whether the brake fluid level in the reservoir is at the MAX (upper) level. If level is low, add fresh fluid until the reservoir is refilled to the
MAX (upper) level.
7. Perform brake bleeding procedures. See: Bleeding
8. Perform ABS sunctional checks using the ALB checker. See: Antilock Brakes / Traction Control Systems/Testing and Inspection